Nanolex Si3D Headlight & Trim

Nanolex Si3D Headlight & Trim provides long-lasting and efficient protection for headlights and polycarbonate surfaces

UV protection against yellowing and aging

Nanolex Si3D Headlight & Trim provides long-lasting and efficient protection for headlights and polycarbonate surfaces against environmental influences and damage caused by UV rays. The coating forms a permanent protective layer consisting of UV-stable ceramic components and special additives on the surfaces that combine to form the characteristic Si3D structure. The result is outstandingly protected, easy-to-clean headlights. Nanolex Si3D Headlight & Trim was developed, tested, and produced in Germany.

Buy now Si3D Headlight & Trim

Professional application of Nanolex Si3D APX coating on Audi vehicle

The new Nanolex Coatings explained in detail

Si3D Headlight&Trim was developed, tested and produced in Germany

Increased UV protection Against yellowing and aging

High protection Against acid rain, insect remains and bird droppings

Easy cleaning Easy cleaning and very good beading properties

Increased protection against scratches

Simple processing

Bundle contains Nanolex Si3D Headlight&Trim (30 ml), an applicator block, four suede cloths and a Nanolex Microfiber Buffing Cloth

How to use Si3D Headlight & Trim?

By following these simple steps, you'll achieve maximum protection and shine for your headlights and trim parts. Nanolex Si3D Headlight & Trim offers an outstanding solution for the long-term protection and care of your vehicle surfaces.

Preparation

Cleaning: Clean the headlights and trim parts thoroughly to remove dirt, dust and impurities. Use a suitable cleaner such as Nanolex EX. Make sure that the surface is completely dry.

Polish: If necessary, polish the surface to remove scratches and create a smooth base for the coating.

Applying the Si3D Headlight&Trim

Application: Apply a few drops of Nanolex Si3D Headlight & Trim to a lint-free application cloth. Spreading: Spread the coating evenly over the surface in circular motions. Work in small sections to ensure the entire area is evenly covered. Allow to work: Allow the coating to work for about 10-15 minutes until it begins to dry.

Polishing and curing

Polishing: Polish the treated surface with a clean, soft microfiber cloth to remove excess product and achieve a glossy finish. Curing: Allow the coated surface to dry for at least 4 hours before exposing it to moisture or other external influences. Full curing occurs after 24 hours. Care: Use mild cleaning agents to care for the coated surface. Avoid harsh chemicals to maximize the lifespan of the coating.